Mr_Chin

Hi All

I've just put an Ermax Undertray with indicators onto my bike. Problem is, that the indicators flash too quickly for both the left turn signal and right turn signal, front and rear indies all work as they should except for the fast flashing speed, BUT, when I use the Hazards there all work fine and at the correct speed.

I know that 'Everybody' will post "Buy the regulator indicator relay thingy", but I had this undertray on my old bike with no problems of the fast flashing - why would this one need a indicator relay rectifier thinga-me-bob?

1. Are the hazards on a different loom to the indicators?

2. I have a Datatool S3, which has the wiring incorporated into the main loom, would this cause the problem?

I'm at work at the moment so any advice is welcome until I get home to have a look.

Cheers

Chin