Hello Everyone.
Just got a question.
I'm not sure how many people will know but a most Honda clutches vary from the Suzuki kind (there a bit more complicated) and I'm after some tips.
My clutch slips at the moment and I have a nice new set of friction and steel plates to put in.
Now here's the hard bit. I need to undo the clutch center locknut and there is no where for me to use the mole grip type clutch holding tool as the whole basket comes off as one piece i.e. Basket, Plates & Hub.
I need to get enough fricton on the clutch to hold it whilst I crack the locknut.
I've thought about loosening the clutch springs off and putting on some washers so there is more tension there and putting into 5th gear & jamming the brake on but does anyone have any other ideas?
Sorry this is a bit lenghty but just trying to give all the info I can.
Ta in advance.
Rob
