SV650.org - SV650 & Gladius 650 Forum - View Single Post - ZX10R shock preload adjustment, c spanner?

25-02-10, 10:46 PM

Hey guys finally getting round to getting my zx10r shock onto my bike, been doing my research ready to do it. All I am wondering is if there is a specific wrench or c spanner eg a kawasaki part i can buy to adjust my pre load, i would rather have it all ready before starting than stop halfway through!

Also if anyone knows the answer to my first question im sure they can resolve this for me once and for all. The adjustment on the reservoir at the top of the shock is the compression damping adjustment right? (marked "comp") Thus making the adjustment under the spring the rebound damping by process elimination right? (marked "ten") Just looking for the straight 100% answer!

25-02-10, 10:46 PM	#1
Elltg Guest Posts: n/a	ZX10R shock preload adjustment, c spanner? Hey guys finally getting round to getting my zx10r shock onto my bike, been doing my research ready to do it. All I am wondering is if there is a specific wrench or c spanner eg a kawasaki part i can buy to adjust my pre load, i would rather have it all ready before starting than stop halfway through! Also if anyone knows the answer to my first question im sure they can resolve this for me once and for all. The adjustment on the reservoir at the top of the shock is the compression damping adjustment right? (marked "comp") Thus making the adjustment under the spring the rebound damping by process elimination right? (marked "ten") Just looking for the straight 100% answer! Last edited by Elltg; 25-02-10 at 10:50 PM.