06-06-10, 04:00 PM
|
#6
|
|
The Sick Man
Mega Poster
Join Date: Nov 2004
Location: Peckham.SE.LDN
Posts: 4,768
|
Re: Fitting a Remus can - The answer
Quote:
Originally Posted by danf1234
TSM,
No I didn't remove the CAT. Because I cut at 7cms it was about 1cms above the cat, so I could leave it intact. Lots of people have cut through the CAT and totally bolloxed it up cutting in the wrong place.
Double walled pipes are on the Curvy, and early pointies too. Newer models have the single walled version.
|
you did remove most of the cat, some of it is in the can itself too, i did not realise there was more in the pipe too, i wander if they added that extra bit in the last couple of years to satisfy Euro3 emission standards along with O2 sensor and dual sparks.
__________________
OTR: KTM 690 Duke R 2015 Full Akro
SIDELINE: Kwak ZX636 A1P 2002, Red, R&G's, Yoshi, Double Bubble Screen
GONE: Kwak ZX-7R P1, Full Akro, Undertray, Screen
GONE: SV650S K2 Very Bruised & Without Fairing, Motovation Frame Sliders, R&G Ally Sprocket Toe Protector, HEL 2 Line Setup, GSXR K1 600 RWU Forks, Barnett Clutch & Springs, Penske 8981 Shock, Gilles Ti Rearsets, Steel Barends, Scottoiler, AFAM Chain & Sprockets, Twin FIAMM Horns, Skidmarx Bellypan, Full Micron Zeta Steel System, Cut down undertay.
Forum Problems & Information / Site Suggestions
|
|
|