SV650.org - SV650 & Gladius 650 Forum - View Single Post - Curvy belly-pan, How do I fit it?

14-09-10, 02:39 PM

assuming they're all the same method of attachment then mine was:
1 long bolt through the hollow loop on the front (bottom) of the engine
Then 2 Z shaped brackets off of either side which were bolted to the belly pan and threaded through said long bolt.
Then there was also a 3rd bracket which was straight and attached the belly pan back to where the exhaust is bracketed on just behind the brake rear set.

14-09-10, 02:39 PM	#2
Owenski Guest Posts: n/a	Re: Curvy belly-pan, How do I fit it? assuming they're all the same method of attachment then mine was: 1 long bolt through the hollow loop on the front (bottom) of the engine Then 2 Z shaped brackets off of either side which were bolted to the belly pan and threaded through said long bolt. Then there was also a 3rd bracket which was straight and attached the belly pan back to where the exhaust is bracketed on just behind the brake rear set.