Re: Yamaha R6/1 Front end on SV?
Took a few measurements today.
Inside hole for steering stem 22mm
R6/R1 triple stem diameter 28mm
total height 28mm, lower section height 15mm, upper reduced diameter height 13mm
lower spacer outer diameter 38mm, upper section diameter 28mm
I currently run 12mm of fork above the triple.
Picked up 98 R1 forks today and confirmed upper triple hole same as R6 so spacer will be similar to the 1st one I had made. The only issue is the R1 forks are 20mm shorter than the R6 so I will probably reduce the spacer bottom section height to 5mm from 15. This will allow me to run the forks approx flush with the top of the triple.
John
|