SV650.org - SV650 & Gladius 650 Forum - View Single Post - How to Start up & run in a sv after a engine rebuild?

muzikill · 09-05-11, 07:19 AM

http://forums.sv650.org/showthread.p...ht=dealer+mode

I bet ya its this, i flippin bet ya....... tps sensor plug was the last thing i connected before i powered it up...... we will see...

One thing i have noticed are my indicators are flashing twice as fast, don't know if this could be a side effect or another issue, oh well.

Another thing it could be is the Flasher relay im sure this has something to do with controlling the emergency cut outs.... more stuff to be bought!

09-05-11, 07:19 AM	#18
muzikill Member Mega Poster Join Date: Jul 2005 Location: Dunfermline Posts: 1,712	Re: How to Start up & run in a sv after a engine rebuild? http://forums.sv650.org/showthread.p...ht=dealer+mode I bet ya its this, i flippin bet ya....... tps sensor plug was the last thing i connected before i powered it up...... we will see... One thing i have noticed are my indicators are flashing twice as fast, don't know if this could be a side effect or another issue, oh well. Another thing it could be is the Flasher relay im sure this has something to do with controlling the emergency cut outs.... more stuff to be bought! __________________ Learn to maintain your bike, take it apart, rebuild the engine & more (using better bolts ), drop it & fix it again! K3 Job c.v: Engine:remove/split/rebuild/refit. Replace:Gearbox,Fuel pump,Gaskets. Piston clean,rings. Overhaul:Throttle body,Injectors,Brakes,Forks. Remove/refit:Exhaust,Radiator,Oil cooler,Throttle,Air filter,Tank. Replace: Oil,Coolant,grease,brake hoses & bleed. Last edited by muzikill; 09-05-11 at 02:09 PM.