Quote:
Originally Posted by inspectorgadget
Have adjusted the clutch both ways at the lever, but not at adjuster near the front sprocket as I'm not really sure how that works.
#
|
take sprocket cover off
set cable adjuster on engine casing about half way
set handlebar adjuster all the way in then about 1 turn out
undo locknut on wormgear (the bit you don't know how it works) turn screw in centre out about 2-3 turns then slowly turn it back in till you feel slight 'resistance' then back screw out 1/4 turn. while holding screw with screwdriver tighten locknut without moving the screw position.
adjust the handlebar adjuster till you have a little free play at clutch leaver.
tighten everything up and test the clutch operation. if the clutch is working then put sprocket cover back on.
on the wormgear screw there is a rod at the back you are looking for the screw to just touch this then back out a 1/4 turn.