SV650.org - SV650 & Gladius 650 Forum - View Single Post - How do you balance the throttle bodies on a K8?

Bibio · 22-09-12, 09:06 PM

shouldn't make that much of a difference but just to make sure try connecting the vacuum gauges again and see if there is a large leap from idle to around 7-8k. wind the throttle slowly when doing it. if one vacuum is a lot larger than the other then you might get problems.

good news is that you might just get the screw back to the original position or near dammit as they are marked with white paint from the factory.

ooohhhh and never ever touch the top screw and if you do then it's out with the verniers to get it back into position.

22-09-12, 09:06 PM	#48
Bibio Member Mega Poster Join Date: Jul 2008 Location: here as devil's advocate Posts: 11,569	Re: How do you balance the throttle bodies on a K8? shouldn't make that much of a difference but just to make sure try connecting the vacuum gauges again and see if there is a large leap from idle to around 7-8k. wind the throttle slowly when doing it. if one vacuum is a lot larger than the other then you might get problems. good news is that you might just get the screw back to the original position or near dammit as they are marked with white paint from the factory. ooohhhh and never ever touch the top screw and if you do then it's out with the verniers to get it back into position.