SV650.org - SV650 & Gladius 650 Forum - View Single Post

Bibio · 19-10-13, 02:34 PM

yes

no

no

never cut into the main bike loom unless you have to. take feed from rear brake light switch and below the connector. or make an inline 'splice' connector using same conectors. also remember that the coil needs to go to negitive. (there is no 'earth' on car/bike electrics it's a negative).

reason you never cut into main loom is that it can cause problems later. always use a feed after a connector so if you do get problems you can replace the item you cut into rather than 'splicing' the main loom.

19-10-13, 02:34 PM	#28
Bibio Member Mega Poster Join Date: Jul 2008 Location: here as devil's advocate Posts: 11,569	Re: cheap heated grips yes no no never cut into the main bike loom unless you have to. take feed from rear brake light switch and below the connector. or make an inline 'splice' connector using same conectors. also remember that the coil needs to go to negitive. (there is no 'earth' on car/bike electrics it's a negative). reason you never cut into main loom is that it can cause problems later. always use a feed after a connector so if you do get problems you can replace the item you cut into rather than 'splicing' the main loom.