SV650.org - SV650 & Gladius 650 Forum - View Single Post

Trev B · 05-03-16, 04:50 PM

Sorry mate I haven't,I'm in Spain until end of April,but what I did was put it on a paddock stand and offer it up and pack it up with some timber into position,I then got some 1 MM x 15 MM bar and then proceeded to cut and bent to suit, I remember 1 went to the exhaust clamp on the throttle side near the brake peddle,and the others just picked up any where I could.No need to undo any casing bolts but I put some 1/2" rubber tape washers either side of the belly pan,followed by chrome washers to cushion followed by some chromed Allen studs and bolts,make sure you leave a fair gap between the pan and the exhaust at the rear or put something heat shield as mine got a little too near and is a lovely toasty colour.not as hard as I thought it would be and as of yet not fallen off,Good Luck

05-03-16, 04:50 PM	#530
Trev B Member Join Date: Aug 2013 Posts: 283	Re: The All new Reeder Megathread Sorry mate I haven't,I'm in Spain until end of April,but what I did was put it on a paddock stand and offer it up and pack it up with some timber into position,I then got some 1 MM x 15 MM bar and then proceeded to cut and bent to suit, I remember 1 went to the exhaust clamp on the throttle side near the brake peddle,and the others just picked up any where I could.No need to undo any casing bolts but I put some 1/2" rubber tape washers either side of the belly pan,followed by chrome washers to cushion followed by some chromed Allen studs and bolts,make sure you leave a fair gap between the pan and the exhaust at the rear or put something heat shield as mine got a little too near and is a lovely toasty colour.not as hard as I thought it would be and as of yet not fallen off,Good Luck __________________ Somewhere up north,Never regret something that once made you smile!!!