SV650.org - SV650 & Gladius 650 Forum - View Single Post - best way to cut the system to fit a race can?

18-03-05, 02:49 PM

i was looking at my bike today and thinking what would be the best way to cut the oe exhaust system,my foot peg and rear brake assembly are in the way.i have been told that a hack saw does the job and also a angle grinder but i dont think i have the room to fit either into the gap i have,the cut has to be 45mm from the welded joint.
do i have to remove the exhaust or could i just lye the bike on its side to get more access?
i would be intrested to know how you fellow sv'ers did your can's?
thanks
daz

18-03-05, 02:49 PM	#1
kwak zzr Guest Posts: n/a	best way to cut the system to fit a race can? i was looking at my bike today and thinking what would be the best way to cut the oe exhaust system,my foot peg and rear brake assembly are in the way.i have been told that a hack saw does the job and also a angle grinder but i dont think i have the room to fit either into the gap i have,the cut has to be 45mm from the welded joint. do i have to remove the exhaust or could i just lye the bike on its side to get more access? i would be intrested to know how you fellow sv'ers did your can's? thanks daz