I just replaced my clutch cable and now I can't get the right feel back in the lever. It is stiffer than it was, but not because there is tension in the cable, it feels mushy and slow. When I release the lever it doesn't spring back all the way either.
I tried adjusting it the way the owner's manual says to, but if I move the lever adjustment all the way in, I can't get the bottom adjustment to pull the cable tight enough. On the lower adjustment, the manual says to loosen both lock nuts then spin the adjuster nut. What is that supposed to do? All mine does is spin freely.
In this pic, the top arrow points at the adjusting nut that spins freely and the bottom two arrows point at the lock nuts that are adjusted all the way up.
Any suggestions?