Quote:
|
Originally Posted by philc2000
Am I right in thinking that if you want to fit an end can on a K4/K5 you need to hacksaw the standard pipe to make it fit? Are there any end cans available that don't require hacksawing?
I don't fancy hacksawing at all, mainly because when I come to sell it I'd want to put the standard can back on.
Is the only alternative a full-system?
|
If you only want to put an end can on, then a hacksaw is involved at some point or another.
Some people buy precut systems or whatever from breakers and put those on, a K4 system should fit a K5.
You can put the original back on with an adapter supplied with most cans, though obviously this will then show that a slip-on has been fitted at some point.
A full system is nice, but a bit expensive considering the relatively minor benefits.