SV650.org - SV650 & Gladius 650 Forum - View Single Post

TSM · 31-08-05, 09:38 PM

I was looking at these again. One consern that i have is that when you want to use the bars at a lower level you cannot bolt the fork clamp into the bottom of the yoke. As brought up my the maker this is possably an issue, does that bolt hold the clamp at all from moving or is it just a locator point. Is it safe not to have it?

Reason i dont think i want a whole two inches higher, probably just one inch.

31-08-05, 09:38 PM	#12
TSM The Sick Man Mega Poster Join Date: Nov 2004 Location: Peckham.SE.LDN Posts: 4,768	I was looking at these again. One consern that i have is that when you want to use the bars at a lower level you cannot bolt the fork clamp into the bottom of the yoke. As brought up my the maker this is possably an issue, does that bolt hold the clamp at all from moving or is it just a locator point. Is it safe not to have it? Reason i dont think i want a whole two inches higher, probably just one inch. __________________ OTR: KTM 690 Duke R 2015 Full Akro SIDELINE: Kwak ZX636 A1P 2002, Red, R&G's, Yoshi, Double Bubble Screen GONE: Kwak ZX-7R P1, Full Akro, Undertray, Screen GONE: SV650S K2 Very Bruised & Without Fairing, Motovation Frame Sliders, R&G Ally Sprocket Toe Protector, HEL 2 Line Setup, GSXR K1 600 RWU Forks, Barnett Clutch & Springs, Penske 8981 Shock, Gilles Ti Rearsets, Steel Barends, Scottoiler, AFAM Chain & Sprockets, Twin FIAMM Horns, Skidmarx Bellypan, Full Micron Zeta Steel System, Cut down undertay. Forum Problems & Information / Site Suggestions