Valve clearances and gsxr600 shock settings
Hello everyone, i've just serviced my friends sv650s K3, all the valve clearance were very tight with some of the inlets being exactly 0.10 mm and the exhausts 0.20. The bike has done 8000 miles and has never been serviced until now. Will it be ok to leave the clearances like they are, i know there tight but there still in spec so would it be ok to check it again in another few thousand miles? Also how hard is it to remove the cams and change the shims? i've always been spoiled by gear driven cams so no messing about!
Secondly i've fitted a gsxr600 k3 rear shock to it, can anyone give me the standard setting for rebound and compression and any tips for the sv
Cheers guys and gals
|