The side panels below the seat.
The push stud fasteners are released by pressing the centre pin in a little until they just click. I use a small bolt with a nut fitted part way down (about 3mm of bolt protruding) so I can't push it through too far. The whole fastener then lifts out.
Don't push the centre pin in too far or it will go right through and into the frame tube.
To re-fit, one way is to push the pin right through the fastener and remove, then put it back in from the head side part way, it has a design feature so that the centre pin will be held in the "primed" position. When you put the panel back on put the fastener into the hole and into the frame, then press the centre pin until it clicks flush again.
|