Hi all,
I just got a fabbri db screen on my K3 and I must admit I'm kinda let down
When I was fitting it, I noticed there is a small gap between the screen and fairing (doesn't fit flush like standard one) on the outside. I can live with this. But on the inside at the top where the screws go is a really nasty gap, about a cm wide.
After further investigation I realised the new screen does not have a recessed section where the plastic thread from the inner fairing meets it (like the standard one has) I suppose I could cut down the bit of plastic the screw from the other side goes into to get a nicer fit. But that shouldn't be necessary. £50 screen should fit snug.
I'm just wondering if I could have done anything wrong? Everyone else seems so happy with their screens...
Cheers.