15-07-06, 11:56 PM
|
#8
|
|
The Sick Man
Mega Poster
Join Date: Nov 2004
Location: Peckham.SE.LDN
Posts: 4,768
|
Quote:
|
Originally Posted by mart
Quote:
|
Originally Posted by TSM
The can angle is a tad off line to the body work, is it possible you have the wrong link pipe, different years of SV pointies had the rear tail piece at a different angle.
The rear brake disk looks good though.
When are you getting the rear wheel to black? Are those 'Braking' front brake disks?
|
well spotted tsm the rear subframe is of a k3 650s and so is the seat and side infill panels the reason higher backend without shorter tie rods the sv doesnt in my mind look good with lowers and a low backend there is also too much seat on the k4+ bikes compared to the k3. yep they are braking point discs and the rear wheel will get power coated in two weeks time |
Ahh they are the Braking Point ones, they are not the same as Braking
__________________
OTR: KTM 690 Duke R 2015 Full Akro
SIDELINE: Kwak ZX636 A1P 2002, Red, R&G's, Yoshi, Double Bubble Screen
GONE: Kwak ZX-7R P1, Full Akro, Undertray, Screen
GONE: SV650S K2 Very Bruised & Without Fairing, Motovation Frame Sliders, R&G Ally Sprocket Toe Protector, HEL 2 Line Setup, GSXR K1 600 RWU Forks, Barnett Clutch & Springs, Penske 8981 Shock, Gilles Ti Rearsets, Steel Barends, Scottoiler, AFAM Chain & Sprockets, Twin FIAMM Horns, Skidmarx Bellypan, Full Micron Zeta Steel System, Cut down undertay.
Forum Problems & Information / Site Suggestions
|
|
|