Heated grips/ with flat or raised bars

As my bike is now my sole transport I'm going to fit heated grips before this winter. However, I'm planning on changing the stock clip-ons for some raised straight bar ones. My question is, how exactly do heated grips (say, Oxford Hot Hands) fit? Will I be able to take them off my existing bars and fit them to the new bars (which realistically, probably won't be done till spring)? Or would it be a lot easier to just do it all in one go (IE fit new bars then fit heated grips to those)?

Again, same question (can I get ones for clip-ons that can later be moved to renthals), but for hand guards?

Oxford Hot Grips...

They're glued on, like the stock ones, so should be a big deal to do it twice. Right pain in the rear trying to pull the stock ones off though, so the hotgrips are staying attached to the bike indefinately.

If I want to keep the grips, the bars from the SV will be fitted to my next bike, it'll be easier.

Originally Posted by Baph

Oxford Hot Grips...

They're glued on, like the stock ones, so should be a big deal to do it twice. Right pain in the rear trying to pull the stock ones off though, so the hotgrips are staying attached to the bike indefinately.

If I want to keep the grips, the bars from the SV will be fitted to my next bike, it'll be easier.

Hmm, looks like I'd best investigate a set of Renthals sharpish. Ta for the info, Baph.

Apologises, I meant that it shouldn't be a big deal to remove the sticky stuff (careful folks, U rating!)

But yea, removing the grips themselves I found to be a swine.