help needed....not starting

sv650 k3...
i had a fault warning appear on the screen, FI or F1 hard to tell....turnes out it a fault code C42. meaning "ignition switch losing signal" might be the ignition wiring loom.
the bike only primes itself for aprox 1 sec than stops and goes no further, will not start. it seems to be an intermitant problem at the moment. always the best ones!!
any ideas what to do?

[fastdruid]

Disconnect and reconnect the ign switch a few times, inspect the connector for damage[1] and use some grease (I use vaseline although it's not the best) to protect it from corrosion.

I don't know what the ign is like on the k3, some bikes you can take the switch part apart and test connectivity etc from there.

Beyond that it's taking a multi-meter and start tracing wires, good luck!

Druid

[1] I had the power feed to the clocks corrode at the wiring block on mine. Give each of the wires a gentle tug, one may fall out.

tried that, but still tempromental.....new switch is about £180....any cheaper options???

[Stu]

Ask http://forums.sv650.org/showthread.p...light=breaking