SV650.org - SV650 & Gladius 650 Forum



Bikes - Talk & Issues Newsworthy and topical general biking and bike related issues. No crapola!
Need Help: Try Searching before posting

Reply
 
Thread Tools
Old 20-06-09, 06:39 PM   #1
TSM
The Sick Man
Mega Poster
 
TSM's Avatar
 
Join Date: Nov 2004
Location: Peckham.SE.LDN
Posts: 4,768
Default Exhaust issues on my 7R

Right, found out that the balancer pipe between 1-2 has rusted at the wealds and broken off on my steel acro pipework.

Do you think that JB weald will hold with the high heat and vibes or do i just have to get it done properly?
__________________
OTR: KTM 690 Duke R 2015 Full Akro
SIDELINE: Kwak ZX636 A1P 2002, Red, R&G's, Yoshi, Double Bubble Screen
GONE: Kwak ZX-7R P1, Full Akro, Undertray, Screen
GONE: SV650S K2 Very Bruised & Without Fairing, Motovation Frame Sliders, R&G Ally Sprocket Toe Protector, HEL 2 Line Setup, GSXR K1 600 RWU Forks, Barnett Clutch & Springs, Penske 8981 Shock, Gilles Ti Rearsets, Steel Barends, Scottoiler, AFAM Chain & Sprockets, Twin FIAMM Horns, Skidmarx Bellypan, Full Micron Zeta Steel System, Cut down undertay.

Forum Problems & Information / Site Suggestions
TSM is offline   Reply With Quote
Old 20-06-09, 08:12 PM   #2
ThEGr33k
Guest
 
Posts: n/a
Default Re: Exhaust issues on my 7R

Quote:
Originally Posted by TSM View Post
Right, found out that the balancer pipe between 1-2 has rusted at the wealds and broken off on my steel acro pipework.

Do you think that JB weald will hold with the high heat and vibes or do i just have to get it done properly?
Id say not, pressure up that high will be pretty harsh, that is going from very high to vacuum... Will no doubt blow back out. Have a look at getting it done right. Will be a bit of a pain in the **** taking the system off, but it shouldn't cost much tbh.
  Reply With Quote
Old 20-06-09, 08:16 PM   #3
TSM
The Sick Man
Mega Poster
 
TSM's Avatar
 
Join Date: Nov 2004
Location: Peckham.SE.LDN
Posts: 4,768
Default Re: Exhaust issues on my 7R

Quote:
Originally Posted by ThEGr33k View Post
Id say not, pressure up that high will be pretty harsh, that is going from very high to vacuum... Will no doubt blow back out. Have a look at getting it done right. Will be a bit of a pain in the **** taking the system off, but it shouldn't cost much tbh.
its all already off as i going to change the exhaust gaskets
doing loads of other work on the 7r while im at it

ile find local wealder and take it there this week
__________________
OTR: KTM 690 Duke R 2015 Full Akro
SIDELINE: Kwak ZX636 A1P 2002, Red, R&G's, Yoshi, Double Bubble Screen
GONE: Kwak ZX-7R P1, Full Akro, Undertray, Screen
GONE: SV650S K2 Very Bruised & Without Fairing, Motovation Frame Sliders, R&G Ally Sprocket Toe Protector, HEL 2 Line Setup, GSXR K1 600 RWU Forks, Barnett Clutch & Springs, Penske 8981 Shock, Gilles Ti Rearsets, Steel Barends, Scottoiler, AFAM Chain & Sprockets, Twin FIAMM Horns, Skidmarx Bellypan, Full Micron Zeta Steel System, Cut down undertay.

Forum Problems & Information / Site Suggestions
TSM is offline   Reply With Quote
Old 20-06-09, 08:38 PM   #4
ThEGr33k
Guest
 
Posts: n/a
Default Re: Exhaust issues on my 7R

Coolio. Hope it all goes back together good.
  Reply With Quote
Old 22-06-09, 01:48 PM   #5
philbut
Guest
 
Posts: n/a
Default Re: Exhaust issues on my 7R

TSM, are you on redmonkey as well? saw a post from someone called TSM who was pretty new to the site. i'm Philbut on there too.
  Reply With Quote
Old 22-06-09, 02:41 PM   #6
TSM
The Sick Man
Mega Poster
 
TSM's Avatar
 
Join Date: Nov 2004
Location: Peckham.SE.LDN
Posts: 4,768
Default Re: Exhaust issues on my 7R

Quote:
Originally Posted by philbut View Post
TSM, are you on redmonkey as well? saw a post from someone called TSM who was pretty new to the site. i'm Philbut on there too.
yup thats me
only started on there about a month ago but have had bike since december
__________________
OTR: KTM 690 Duke R 2015 Full Akro
SIDELINE: Kwak ZX636 A1P 2002, Red, R&G's, Yoshi, Double Bubble Screen
GONE: Kwak ZX-7R P1, Full Akro, Undertray, Screen
GONE: SV650S K2 Very Bruised & Without Fairing, Motovation Frame Sliders, R&G Ally Sprocket Toe Protector, HEL 2 Line Setup, GSXR K1 600 RWU Forks, Barnett Clutch & Springs, Penske 8981 Shock, Gilles Ti Rearsets, Steel Barends, Scottoiler, AFAM Chain & Sprockets, Twin FIAMM Horns, Skidmarx Bellypan, Full Micron Zeta Steel System, Cut down undertay.

Forum Problems & Information / Site Suggestions
TSM is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
oil issues Brettus SV Talk, Tuning & Tweaking 9 24-11-08 08:39 PM
3 Issues Phaelok Bikes - Talk & Issues 11 28-10-08 11:06 PM
DNS Issues Jelster Idle Banter 6 05-02-07 05:59 PM
TRE Mod - now FI light issues nbf6165 SV Talk, Tuning & Tweaking 2 14-12-06 04:01 PM
Oil issues..... lynw SV Talk, Tuning & Tweaking 13 18-11-04 08:36 PM


All times are GMT. The time now is 06:15 AM.


Powered by vBulletin® - Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.