SV Talk, Tuning & Tweaking Discussion and chat on all topics and technical stuff related to the SV650 and SV1000 Need Help: Try Searching before posting |
![]() |
|
Thread Tools |
![]() |
#1 |
Guest
Posts: n/a
|
![]()
I have done part finder and local breakers found a few looms but all seem to be slightly different my wife's has a code number then 3 letters but can't find a exact match on the code or numbers have also compared it to some of the looms and there is differences at this moment it is looking like i will have to buy a new loom at £360.00 gulp does any one know which looms will be the same i know the k5 on are different as the fuel pump has a brown 4 pin square connector and obviously the carbed ones are different, is it because it's a naked that i am struggling? hers is a k4 any help greatly appreciated. Craig
|
![]() |
![]() |
#2 |
The Sick Man
Mega Poster
Join Date: Nov 2004
Location: Peckham.SE.LDN
Posts: 4,768
|
![]()
i have a loom for a pointy bike, cant remember if its for a faired or nakid
ive taken the alarm out of the loom so i would have to just reconnect a couple of wires and it will be fine
__________________
OTR: KTM 690 Duke R 2015 Full Akro SIDELINE: Kwak ZX636 A1P 2002, Red, R&G's, Yoshi, Double Bubble Screen GONE: Kwak ZX-7R P1, Full Akro, Undertray, Screen GONE: SV650S K2 Very Bruised & Without Fairing, Motovation Frame Sliders, R&G Ally Sprocket Toe Protector, HEL 2 Line Setup, GSXR K1 600 RWU Forks, Barnett Clutch & Springs, Penske 8981 Shock, Gilles Ti Rearsets, Steel Barends, Scottoiler, AFAM Chain & Sprockets, Twin FIAMM Horns, Skidmarx Bellypan, Full Micron Zeta Steel System, Cut down undertay. Forum Problems & Information / Site Suggestions |
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
![]()
or spend £100 and make your own?
|
![]() |
![]() |
#4 |
Guest
Posts: n/a
|
![]()
don't fancy the second option ! was hoping to find a unmolested loom hope fully.
|
![]() |
![]() |
#5 |
Guest
Posts: n/a
|
![]() |
![]() |
![]() |
#6 | |
Guest
Posts: n/a
|
![]() Quote:
you wont belive it was just flicking through mcn and saw there advert 30mins ago went on and bingo paid for was going to post a thread and link put you have beat me too it. |
|
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Curvy Sub Loom | Demonz | Stuff Wanted | 0 | 12-07-09 08:18 PM |
After swapping the loom out. | Grinch | SV Talk, Tuning & Tweaking | 44 | 08-12-08 11:34 PM |
Wiring loom | Binky | Stuff Wanted | 3 | 19-08-08 08:24 PM |
left hand lower and left hand tail piece | malks | Stuff Wanted | 2 | 02-06-08 09:56 PM |
Where can I find clutch housing bolts? - Cant find any | mikeSV | SV Talk, Tuning & Tweaking | 2 | 24-03-08 12:30 PM |