Exhaust can Remus lambda sensor.

Hi everyone im going to fit remus can to stock system will it make any problems with lambarda sensor,sv650 2007 thanks

not if its only the end can your changing, you should be cutting the standard pipe past the sensor.

[Bibio]

take the sensor off before you cut or mess with the pipe. they are quite delicate and easy to break. you dont want to know the price of a new one as they are a specific type and are not available as an after market item.

Thanks guys just wanted to be sure so i will remove the sensor before i cut the pipe

measure twice, cut once

sounds like good advice thanks

Originally Posted by Alpinestarhero

measure twice, cut once

...or cut it first time roughly 5cms to the left of the weld?

i used permanent marker where too cut and a grinder and marvelled at the spark's and destruction created.

Thanks everyone

I'm pretty sure that the K7 onwards annoyingly have a catalitic converter situated just about where you are going to cut. I think that the cat ends somewhere near the 55mm mark from the weld. Can somebody who has cut a K7/K8/K9 exhaust please advise me where to cut in order to avoid cutting the cat? I have ordered a Blue Flame can and so will face a similar dilemma soon.