![]() |
#1 |
Guest
Posts: n/a
|
![]()
Hello folks,
I need to replace the steering head bearings on my SV. I got the bearings, but now need the special Suzuki tool to refit & tighten down the large special nut just under the upper triple clamp. It's a long shot but has anyone close to Dublin got one I could borrow or does any one know if it is possible to make your own(as I can imagine it is expensive to get from Suzuki). If I can't get one, does anyone know if it makes a huge difference if you: Tighten it up using a hammer & punch, until all play is removed from steering, but steering still falls easily side to side, or Go strictly by the manual using the special tool & torque settings? Thanks, George |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
![]()
Howya George,
Dont have any tools like that But if you need a hand or a hanynes manual gimme a shout Sorry for not being much help ![]() Dar |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
![]()
Is it a G style clamp thing your looking for?
Dar |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fitting steering head bearings? | SVGeorge | SV Talk, Tuning & Tweaking | 10 | 06-09-10 03:18 PM |
steering head bearings... curvy | trouty | SV Talk, Tuning & Tweaking | 8 | 21-04-09 02:11 PM |
Replacing steering bearings | mnrsmith | SV Talk, Tuning & Tweaking | 11 | 10-02-09 11:11 PM |
Steering head bearings - lifespan? | Fizzy Fish | SV Talk, Tuning & Tweaking | 6 | 30-06-08 06:37 PM |
Steering Head Bearings | rjh | SV Talk, Tuning & Tweaking | 3 | 13-10-04 02:12 PM |