engine surging at tickover - SV650.org

coldtyres · 22-07-06, 12:32 PM

Hi guys
I noticed yesyerday on the way home down the motorway that the bike was not running as smooth as usual. It surges a small amount throughout the rev range, and is more noticeable when idling. if i blip the throttle when parked up the revs dont settle quickly it surges about 200 - 300 revs before after about ten seconds it settles down to idle a bit smoother at about 1300rpm. I am useless mechanically so all I have done so far is change the spark plugs today which has not changed a thing.
Any advice would be much appreciated, as its not due for a service for another 800 miles.
Cheers Ryan

jambo · 22-07-06, 02:09 PM

Hiya, Not sure if you've got a curvey (up to 2002) or pointy (2003 onwards). If you have a curvey I would suggest checking that the choke cable is moving smoothly, and not sticking or cracked anywhere along the line. ALso when were the cabs or injectors last balklenced? How many miles does the bike have on it?

coldtyres · 22-07-06, 02:37 PM

Hi there
Thanks for the interest.
Its a curvy and has done 25000miles, so i think the next service is the carb sync one. I did try and look at the choke cable but couldnt tell by looking wwhether its sticking . Is there any way of knowing which one of those it could be? Is there any way I can check it.
Thanks again
Ryan

22-07-06, 05:11 PM

Things to check...

Are the throttles returning correctly or getting stuck? Oiling throttle cables may help here, as may oiling/greasing the throttle mechanism.

Throttle Position Sensor

Might be stuck chokes, removing the plungers a pain the the proverbial (expect to replace the screws), although would expect the bike to be very rough if it was this.

MT

23-07-06, 12:17 PM

check for a vacuum leak

23-07-06, 02:13 PM

Quote:

Originally Posted by empty

Things to check...

Are the throttles returning correctly or getting stuck? Oiling throttle cables may help here, as may oiling/greasing the throttle mechanism.

Throttle Position Sensor

Might be stuck chokes, removing the plungers a pain the the proverbial (expect to replace the screws), although would expect the bike to be very rough if it was this.

MT

Not necessarily, The front plunger was stuck in the open position on mine. It ran what I can best describe as "a little lumpy" but when using the revs more vigorously I couldn't tell the difference.

coldtyres · 05-08-06, 08:45 PM

I have seemingly fixed the problem. I pulled the choke switch as far open as i could and shut it and it was idling much better. I suspect therefore that the choke switch was a little stiff because I had not been using full choke to start in the warmer weather so it hadnt been pulled fully open for a few months.
It feels much nicer to ride now its smooth on the throttle again.
Cheers Ryan

22-07-06, 12:32 PM	#1
coldtyres Member Join Date: Dec 2005 Location: Brisbane Australia Posts: 63	engine surging at tickover Hi guys I noticed yesyerday on the way home down the motorway that the bike was not running as smooth as usual. It surges a small amount throughout the rev range, and is more noticeable when idling. if i blip the throttle when parked up the revs dont settle quickly it surges about 200 - 300 revs before after about ten seconds it settles down to idle a bit smoother at about 1300rpm. I am useless mechanically so all I have done so far is change the spark plugs today which has not changed a thing. Any advice would be much appreciated, as its not due for a service for another 800 miles. Cheers Ryan

22-07-06, 02:09 PM	#2
jambo Member Mega Poster Join Date: Aug 2003 Location: Croydonia Posts: 5,376	Hiya, Not sure if you've got a curvey (up to 2002) or pointy (2003 onwards). If you have a curvey I would suggest checking that the choke cable is moving smoothly, and not sticking or cracked anywhere along the line. ALso when were the cabs or injectors last balklenced? How many miles does the bike have on it? __________________ Modern motorcycles are bloody brilliant, enjoy it while we can

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Surging problems	mikeyd	Bikes - Talk & Issues	8	01-05-09 12:06 PM
Slight surging problem	noob-saibot	SV Talk, Tuning & Tweaking	15	19-12-08 06:20 PM
Surging.	yorkie_chris	SV Talk, Tuning & Tweaking	9	14-11-08 01:28 PM
problems with surging sv1000	silver1000	SV Talk, Tuning & Tweaking	5	15-10-07 08:50 PM
surging revs but delayed power	grecian9	SV Talk, Tuning & Tweaking	22	17-09-06 11:43 PM

22-07-06, 02:37 PM	#3
coldtyres Member Join Date: Dec 2005 Location: Brisbane Australia Posts: 63	Hi there Thanks for the interest. Its a curvy and has done 25000miles, so i think the next service is the carb sync one. I did try and look at the choke cable but couldnt tell by looking wwhether its sticking . Is there any way of knowing which one of those it could be? Is there any way I can check it. Thanks again Ryan

22-07-06, 05:11 PM	#4
empty Guest Posts: n/a	Things to check... Are the throttles returning correctly or getting stuck? Oiling throttle cables may help here, as may oiling/greasing the throttle mechanism. Throttle Position Sensor Might be stuck chokes, removing the plungers a pain the the proverbial (expect to replace the screws), although would expect the bike to be very rough if it was this. MT

23-07-06, 12:17 PM	#5
RandyO Guest Posts: n/a	check for a vacuum leak

05-08-06, 08:45 PM	#7
coldtyres Member Join Date: Dec 2005 Location: Brisbane Australia Posts: 63	I have seemingly fixed the problem. I pulled the choke switch as far open as i could and shut it and it was idling much better. I suspect therefore that the choke switch was a little stiff because I had not been using full choke to start in the warmer weather so it hadnt been pulled fully open for a few months. It feels much nicer to ride now its smooth on the throttle again. Cheers Ryan