Who makes this Paddock stand?

it does but doesnt fold flat in the van or trailor and it harder to put the bike on,not as sturdy and tends to try and chop your fingers off if you make a slight mistake holding it lol a lad i know at racing uses one and its aweful lol the one in the drawing is the dogs ******** trust me :P haha

OK, having failed miserabley to find the maker of this I have updated the design and I'll be making one of these...

Originally Posted by ryangarside

it does but doesnt fold flat in the van or trailor and it harder to put the bike on,not as sturdy and tends to try and chop your fingers off if you make a slight mistake holding it lol a lad i know at racing uses one and its aweful lol the one in the drawing is the dogs ******** trust me :P haha

The type in the drawing is the dogs but not that one in particular, Ebay I think the sellers called Ricambi-weiss in Germany £40 on buy it now, I used them all the time for my race bikes, no worries with them.

Peter

Originally Posted by Berlin

i've done a lot more digging on this and it turns out that they *might* be called "kwikstand" but it looks like the company went under.

So I'll make one

I think what you may mean is "Trikstand" and I believe they are still in business on the IoM. I've got one like the below and it's pretty good, and folds completely flat.

+ 1 for the trickstand (http://www.trikbitzracing.iofm.net/trikstand.htm) . I've used the front and back ones for 10 years, and no problems....

...until I got the SV, and the fairing is so low at the front you can't get to the bottom yoke hole..... but that would be an issue for any stands that use the bottom yoke and a horizontal bar.

I can send you a picture of one. Tried to upload it to here but too big. Mine fits a ZXR 400 at the moment and needs modifying again for the SV650. I've also used it on 600RR,R6 and FZX400.