cable connectors

Originally Posted by Baph

Easier to extend the wires that's there a little really. It's pretty close to the heatshrink, unless you want to pull that back a little & replace the connectors.

I can't remember if the Maplin connectors come supplied with the pins or not, I doubt they do, as Maplin sell them seperately too.

i dont mind cutting the origanal wires.......as they are a bit long & cable tied to the forks

For all Accumate stuff including extension leads:-
http://www.accumate.co.uk/cg020001.htm

I've just had a look on the website & can't see the connectors either, but I know they sell them.

In the Llandudno store, walk in through the door, take the 3rd aisle, walk until you're almost at the components counter, turn right, look at the middle gondola (Maplin speak for "metal shelving unit") & they're about half way down. Does that help?

Seriously, if you want to do it that way, with the proper connector, take the controller in to the store (or ride the bike to the store & get them to come out & have a look if it's fixed to the bike). They should be able to point it out to you. If they can't, grab a catalogue & slap them round the face with it, then look in the "Power connectors" section.

as long as they get hot, i dont care how they are connected