Idle Banter For non SV and non bike related chat (and the odd bit of humour - but if any post isn't suitable it'll get deleted real quick). There's also a "U" rating so please respect this. Newbies can also say "hello" here too. |
|
Thread Tools |
20-04-16, 01:11 PM | #1 |
Member
Mega Poster
Join Date: Mar 2004
Location: Not in Yorkshire. (Thank God)
Posts: 4,116
|
New question for the ORG plumbers
The Mira shower has given up the ghost and I have bought a new one in the naive thought it could possible be a like for like replacement.
But. The cold water inlet on the new shower is plastic. The old one was a compression joint. So could I use the compression elbow or should I remove it and use a push on. There is not much room to work so ideally I would like to continue with the compression. But when I have done so with plastic in the past needed an insert. The new Mira shower has a small filter where you would normally put a pipe insert. Advice please.
__________________
Not Grumpy, opinionated. |
20-04-16, 03:12 PM | #2 |
Member
Mega Poster
Join Date: Mar 2004
Location: Not in Yorkshire. (Thank God)
Posts: 4,116
|
Re: New question for the ORG plumbers
to answer my own question, it wasn't a like for like swap either so I needed an extra 2" of pipe. so compression to plastic and then a pushon between the compression and the shower inlet.
Leak free (for now)
__________________
Not Grumpy, opinionated. |
21-04-16, 10:33 PM | #3 |
Knob faced knobster
Mega Poster
Join Date: Jan 2005
Location: Haslemere
Posts: 5,419
|
Re: New question for the ORG plumbers
I'll answer even though you've sorted it already.
Yes you can use a compression fitting onto the plastic inlet without an insert as its a hard plastic whereas the plastic pipes are soft and flexible so need the insert. When using a compression fitting into plastic I normally use a copper olive.
__________________
2001 SV650 in shimmerin green, Not broken anymore |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Quick question for the org plumbers | DarrenSV650S | Idle Banter | 13 | 11-04-16 05:37 PM |
Question For The Org Plumbers.. | Stuuk1 | Idle Banter | 20 | 22-03-13 11:01 PM |
Question for Org Plumbers | aliwakeskate | Idle Banter | 7 | 20-02-12 10:52 PM |
question for org plumbers and heating engineers | timwilky | Idle Banter | 12 | 28-10-10 09:24 PM |
Plumbers - combi boiler question | steveg | Idle Banter | 28 | 04-11-08 09:11 AM |