running on one cylinder in slow right hand bend - SV650.org

10-12-04, 05:35 AM

My SV650 of 2000 occasionally fails to deliver when asked in slow tight right hand bends. This behaviour is intermittent and appears to be less likely when the bike has just been serviced. It is most likely to occur turning right from standstill at an intersection; this is sometimes inconvenient in relation to other (larger) vehicles.

There are no modifications to the engine.

Has anyone else had this experience?

Is there a solution?

Grant
Sydney
Australia

10-12-04, 10:19 AM

could it be the sidestand switch causing problems???

10-12-04, 02:02 PM

It sounds like the engine is starving fuel. If it has carbs, the float bowl could be set wrong which means that when the bike is leaned at a certain angle, there is not enough fuel in hte carb and because the engine is starting from idle (when taking off) there is no velocity in the fuel air mixture to create enough of a vacuum to pull more through.

That's a guess...

10-12-04, 03:32 PM

I'd have to agree with Scooby.

I had a similar problem with my K1, every time the bike went off centre it would stall on me. In a straight line it was fine, but lean it over and it would stall. Bit of a problem if you wanted to go around a corner!

Took it into the garage they emptied and reset the float bowls and I haven't had a problem since, and that was 9 months (3,500 miles) ago.

Gary

10-12-04, 05:35 AM	#1
grant arbuthnot Guest Posts: n/a	running on one cylinder in slow right hand bend My SV650 of 2000 occasionally fails to deliver when asked in slow tight right hand bends. This behaviour is intermittent and appears to be less likely when the bike has just been serviced. It is most likely to occur turning right from standstill at an intersection; this is sometimes inconvenient in relation to other (larger) vehicles. There are no modifications to the engine. Has anyone else had this experience? Is there a solution? Grant Sydney Australia

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
K6 running on one cylinder.	Smoggy	SV Talk, Tuning & Tweaking	29	16-03-09 11:03 PM
Too much oil on the K&N, now running on 1 cylinder...	Troy	Bikes - Talk & Issues	26	24-07-08 06:21 AM
RUNNING ON 1 CYLINDER	jmsvuk	SV Talk, Tuning & Tweaking	2	13-02-06 04:53 PM
Help - running on 1 cylinder	buckstone	SV Talk, Tuning & Tweaking	3	23-01-06 05:55 PM
1 cylinder running	Scoobs	SV Talk, Tuning & Tweaking	6	11-02-05 10:05 PM

10-12-04, 10:19 AM	#2
zx6man Guest Posts: n/a	could it be the sidestand switch causing problems???

10-12-04, 02:02 PM	#3
Scooby Drew Guest Posts: n/a	It sounds like the engine is starving fuel. If it has carbs, the float bowl could be set wrong which means that when the bike is leaned at a certain angle, there is not enough fuel in hte carb and because the engine is starting from idle (when taking off) there is no velocity in the fuel air mixture to create enough of a vacuum to pull more through. That's a guess...

10-12-04, 03:32 PM	#4
plot241 Guest Posts: n/a	I'd have to agree with Scooby. I had a similar problem with my K1, every time the bike went off centre it would stall on me. In a straight line it was fine, but lean it over and it would stall. Bit of a problem if you wanted to go around a corner! Took it into the garage they emptied and reset the float bowls and I haven't had a problem since, and that was 9 months (3,500 miles) ago. Gary