PDA

View Full Version : Hel Brake lines -custom


CheGuevara
16-06-09, 11:54 AM
I ordered these for my GSXR front end conversion with risers/fat-bars. I guessed that SV-N length, with GSXR (K6/7 600/750) fittings would be about right, but they're a little on the snug side.

These are brand new and have never been filled with fluid (although there may be some that's dribbled out of my "empty" M/C into the line). I have mounted them to the bike (just more than finger tight, so the crush washers are still good), and while the fit is probably OK, if I can sell these quickly I'll order a new set an inch or so longer.

I suspect the length difference might be in the banjo-fitting position on the caliper end, or the bars I'm using. I can measure these ones, but length s/b whatever Hel specs for an N.

Probably suitable for a conversion using non-radial brakes. Might work with a stock N, or even an S if you don't mind them a little on the long side.

Black end fittings with carbon cover (that's smoke really, not a fake carbon-weave look). £40

http://i162.photobucket.com/albums/t247/bigfastyellow2/SV650/P1010311.jpg

stevo_sv
16-06-09, 04:45 PM
If its not too much trouble could you measure them please?

I'm in need off some for my gsxr caliper's.

CheGuevara
16-06-09, 05:22 PM
Will do - I have to spend some quality time with the wife this eve, but will head out to the garage in the AM before work (unless I can find the measurements I took previously before then) :)

CheGuevara
16-06-09, 06:57 PM
Managed to steal a few precious garage moments. Results (both centre-of-banjo to centre-of-banjo, give or take a few mm as best I can hold the line and a tape measure straight):

RHS = 760mm

LHS = 735mm

stevo_sv
19-06-09, 04:41 PM
i managed to mock up the length i'd need earlier and yours are about 3-4cm too short :(