View Full Version : bar ends
after some original oem bar end if anyone has some ?
myfirstsv
29-07-11, 12:43 AM
I just got replacement ones on EBay from Pro Bolt for 20 quid. The ones that were on there were about 2" and (I felt) stuck out too far. The new ones are about 1.5" and feel loads better. They also come with Hex bolts rather than the "toffee" Phillips screws on the originals. And they needed an extra shim to tighten fully.
are they the same weight as the oem bar ends, just trying to cut down the vibrations a bit so thought best option is oem ones as they dont seem to do heavy bar ends for curvy as when i was sent some they were for a pointy and had no chance fitting the curcy and then when i complained i was told they are the only ones and they will admend the ad.
charlie
by any chance u need the old ones? are they the originals?
Chris Bird
29-07-11, 10:06 PM
I've got originals, just sold my clip ons but still have the oem bar ends and all the necessary gubbins
http://i1110.photobucket.com/albums/h450/sv650sk6chrisbird/4b91a73b.jpg
PM me if your interested.
vBulletin® , Copyright ©2000-2025, Jelsoft Enterprises Ltd.