Hamicad tail tidy ......

[Mr P]

.... will be fitting tommorrow.

Instructions reckon an hour - anyone validate this or have any other hints to avoid unforeseen pitfalls?

Cheers

[Carsick]

You can do it in an hour, yes. The only properly fiddly bit is doing the bolts back up once you've got the hamicad back on; the undertray covers them so you have to flex it to get to them.

[Mr P]

Cheers!

[kwak zzr]

mines on order!

[Mr P]

Got round to fitting it this morning.

Fairly Straight forward, instructions are pretty good, and no major fitting problems - apart from (right at the end) dropping the seat release cable bolt back into the seat cowl area and having to take it all off again - doh! :roll:

I presume most people also change their number plate at the same time? as I had to drill two new holes to refit the stock one, and it (just) fits, so will probably get a slightly smaller one.

What do people do about the rear reflector which I believe is needed for MOT?

[M.C.]

this is where i put mine used the std reflector, i made a metal bracket and bent it around so that it sits on top of the number plate light then i drilled a hole in the top of the light and secuered it with a m3 screw and nylock nut
http://i2.photobucket.com/albums/y13/cliomark/myK5SV9A.jpg

[Lee Rainbow]

the hardest thing i found was taking out the little black popper fittings which hold it together