Re: How to clean a downpipe?
 

Glad I found this thread. Have ordered some Optiglanz for my pipes, and a Beowulf radiator guard. Coooool.\\:D/

Re: How to clean a downpipe?
 

I did clean mine eventually :D
I'll try to post some pictures up tomorrow if I remember.
Good light and decent sand paper is key to getting it all off. Unfortunately the grand of sand paper I used was a tiny bit too soft and I was restricted to a garage lamp in a garage. Still mighty impressed with how clean the downpipe is now, but it's no where near the quality shine the guys before have got :(

Re: How to clean a downpipe?
 

I have just bought a similar rad guard from Beowulf. How have you fixed it to the rad? Mine has not come with any fixings at all.

Edit Just found out mine is for the N model which will have the bolts in the rad. Mine is a S model with 2 small indents each side where the bolts should go. Beowulf will send me FOC 4 M5x12mm s/s bolts. I assume there is enough thickness in the rad at these points for the bolts, as the rad is essentially the same for both models to start with

Re: How to clean a downpipe?
 

Are down pipes on a curvy stainless ?

Re: How to clean a downpipe?
 

yes

Re: How to clean a downpipe?
 

ohhh right,will have a go at mine soon !!

Re: How to clean a downpipe?
 

Mep, they are the original bolts. The the two alloy end trims off and bolt the Beowolf in it's place.