Bolt size for 'Cr@p Flap'
 

Hi all,

Does anyone know what size bolt is needed and where can you pick one up for the cr@p flap between the rear wheel and the shock? I decided to put mine on today after having it removed for some time but can't seem to find the bolt to attach it. It's for a pointy but I think they're the same as the curvy?

Any help would be greatly appreciated.

Thanks

Re: Bolt size for 'Cr@p Flap'
 

Not 100% sure but it is most likely a M6 x 1.25 pitch x 15mm.

Re: Bolt size for 'Cr@p Flap'
 

Yup, with a big head IIRC.

Re: Bolt size for 'Cr@p Flap'
 

Cheers guys - you dont suppose know where I could get 1? I've tried busters, fleabay, screwfix, b and q, intobikes and cant find one - I'll keep looking but if you think of anywhere can you let me know?

Cheers

Re: Bolt size for 'Cr@p Flap'
 

Any DIY shop will have them, or you could be tarty like me and get a titanium bolt from Probolt.

Re: Bolt size for 'Cr@p Flap'
 

Cheers mate - thiink I'll get a shiny one from ere - just wanted to check 1st though, I can only see m6x15mmx1.0 pitch (not 1.25 pitch). Am I looking in the wrong place?

Ta

Re: Bolt size for 'Cr@p Flap'
 

Sorry, I was thinking in M8 pitch. Yeah, 1.00 is the standard M6....



Sorry

Re: Bolt size for 'Cr@p Flap'
 

cheers guys - much appreciated - I'm off down to b & q to see if I can get a cheap one!!

Ta-ra

Re: Bolt size for 'Cr@p Flap'
 

Been thinking a bit more, could be a M8 x 1.25 pitch x 15mm....

Re: Bolt size for 'Cr@p Flap'
 

sorted - got one from b&q - it was a m6 but I could only get a 20mm but as it turns out that goes in fine too - so thanks for all your help!!! 9p for the bolt BTW