![]() |
New problem with bike . . . cutting out
Now that the bikes back on the road and sorted, it seems to have developed a new problem . . .randomly, but not often.
When about to pull away, as I begin to give it some throttle it cuts out, this happens instantly, but starts fine straight after. The way in which it cuts out (really quickly) makes me think its something electrical, such as a dodgy cut off switch, or side stand switch. Obviously it could probably be because of a number of other things, but dont think its anything to do with the previous carb problem. If anything its just annoying as it looks like Im stalling the bike!:) But will prob end up getting worse if I dont figure it out. Anybody else had a similar problem? cheers |
Re: New problem with bike . . . cutting out
how old is it?
|
Re: New problem with bike . . . cutting out
See his sig :-P
I'd say sidestand switch and start lobbing the wires off the relay and bypassing it entirely. Idiot switches are no use to anyone, you will only forget about the sidestand once... |
Re: New problem with bike . . . cutting out
Apart from the electrical problems is your tickover set a bit low?
|
Re: New problem with bike . . . cutting out
Quote:
|
Re: New problem with bike . . . cutting out
Yes. Possibly your problem there. 1300rpm +/- 100
|
Re: New problem with bike . . . cutting out
Quote:
|
Re: New problem with bike . . . cutting out
Try up the idle see if it works. If not then start chopping wires.
|
Re: New problem with bike . . . cutting out
Quote:
|
Re: New problem with bike . . . cutting out
Quote:
Turn the idle up, and check the carb balance. I had carbs that were out of balance, and when the engine was warm it did the same thing. |
All times are GMT. The time now is 09:58 PM. |
Powered by vBulletin® - Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.