Hel Braided Hose Help
 

HI i have just fitted my new hel braided hose 2 line setup to the front of my sv650s the hoses are quite long just wondering if anyone has pictures of how they have routed the lines.

Re: Hel Braided Hose Help
 

Did you do what I did ? Have you brought N lines from weemoto by picking the wrong section on their site?

Re: Hel Braided Hose Help
 

Here we go, if they look like this then they are the wrong lines

http://i132.photobucket.com/albums/q37/5hort5/b2-1.jpg

Re: Hel Braided Hose Help
 

They look similar to that but im 100% sure i ordered the rights ones i used the hel website. Perhaps they sent me the naked version. They did forget to send me the banjo bolts for rear so possible another mistake.

Re: Hel Braided Hose Help
 

Yer possible, hopefully my new ones will be here for the weekend and then I have them fitted and take a pic for comparison. I was sure I ordered the right ones, well, that was until I was sent the order form back, my order just said SV650 lines, my new order says sv650S but they should change em without any issues.

Re: Hel Braided Hose Help
 

K thanks looking forward to seeing the photo comparison. I will have to get on the phone and check my order.

Re: Hel Braided Hose Help
 

Well here are the brake lines fitted (lightly), they still look long but the pack says the correct lines and they are shorter than the N ones I tried last weekend. Do you reckon they should route on the inside of the throttle cables as shown or on the outside? On the outside they seem to catch on the fairing and on the inside on full lock they seem to touch the radiator?

http://i132.photobucket.com/albums/q37/5hort5/b1-2.jpg

Re: Hel Braided Hose Help
 

Anybody? Wouldn't mind tightening these up so is it right now? - Many Thanks

Re: Hel Braided Hose Help
 

Mine route the same way yours do but they don't seem to be as long. Mine neither foul the faring, or the radiator.

Re: Hel Braided Hose Help
 

Thanks rich, these are the correct lines this time so I'm a bit lost what to do with them, I can shorten them by putting the bottom bango's out to say 45 degrees and this would shorten them enough but can I do that? would that then fail the mot or anything?