Fitting heated grips - keep spinning round the throttle!
 

I've got oxford heated grips and have had them on since October-ish, no matter what I try to use to 'stick' them on, a few weeks later the grip starts spinning round the throttle thing.
The inside of these grips are just straight smooth plastic, no rubber, no ridges or notches.

Ive tried:
Electrical tape (worked best for a month or so)
Epoxy resin
Silicone
No more nails
Some plumbers pipe tape stuff.

Any ideas? It's getting frustrating now

Re: Fitting heated grips - keep spinning round the throttle!
 

Hairspray, seriously its what I've always used for my grips

Re: Fitting heated grips - keep spinning round the throttle!
 

Knew somebody would reply with that. I used it religiously on my mountain bike stuff and it worked fine, when I tried it with these it works for about 150 miles before 'letting go'.

I think it's because these are just hard shiny plastic on the inside on the grips, and being heated doesn't help because it softens whatever I use.

Thanks for the prompt reply

Sent from my C6603 using Tapatalk

Re: Fitting heated grips - keep spinning round the throttle!
 

Then maybe you need to roughen up the plastic so whatever you use has something to grip onto.

Epoxy is too stiff to use, I'm surprised silicon didn't work, although it might be better leaving for a few days to really cure properly

Re: Fitting heated grips - keep spinning round the throttle!
 

Yeh I may have to give that a go. I'll rough it up and try get some quick drying silicone

Sent from my C6603 using Tapatalk

Fitting heated grips - keep spinning round the throttle!
 

+1 for roughing up the inside.

I'm surprised the epoxy didn't work as that normally "melts" rubber.

Depending on how the other stuff works you could try this..

Get a few bicycle puncture repair patches, stick them to the throttle tube and let them properly set. then after roughing up the inside of the grip use the glue you get in the kits. That may work better as it's 2 rubber surfaces binding then as opposed to the plastic of the tube.

Re: Fitting heated grips - keep spinning round the throttle!
 

I've used Renthal grip glue, never had any problems with it.

Re: Fitting heated grips - keep spinning round the throttle!
 

How high are you heating the grips upto? I used duct tape to get a tight fit then hairspray, slotted them on, left em for a good 2/3 hours then I used em but never heated up more than half way as was plenty warm..

Re: Fitting heated grips - keep spinning round the throttle!
 

+1 for rental grips glues and roughing up the edges with some wet and dry.

Re: Fitting heated grips - keep spinning round the throttle!
 

Superglue works for me.