Carb balancing advice?
 

Hi Guys,

Been having a go at syncing my carbs but using a mates own made manometer i believe has knocked them out of sync worse to the point where the bike isn't starting. I have managed to borrow some proper mechanical gauges to get them sync'd but the screw is well out.

Is there a default position i can put the screw to just to get it up and running again.

Just so you know the bike only stopped running when i started messing with the sync screw. Which way when screwing it increases and decreases vacuum?

Thanks in advance.

Si

Re: Carb Syncing Advice
 

have you been turning up/down the idle screw while you are adjusting the vacuum?

Re: Carb Syncing Advice
 

Bad eye close them fully then take two turns back out it should start but run ****ty

Re: Carb Syncing Advice
 

U have a set of twin morgan carb tune for sale cheap mate

Re: Carb Syncing Advice
 

Best way to get them basically close is to back the idle stop right off so the butterflies should both be fully closed. With the screw backed off, adjust the balancing adjuster so they are both as near as you can tell going fully closed, check this by looking into the intakes (lift the slides as necessary, don't drop anything in there!). You can usually feel when the butterfly "bottoms out" if you are careful.

Then adjust the idle stop screw up a bit and it should be close enough to get you started.

Re: Carb Syncing Advice
 

As embee says...better than I put it ll

Re: Carb Syncing Advice
 

Thanks for the advice guys, i'll give it a blast 2moz and report back.

Re: Carb balancing advice?
 

How have you got the rear cylinder connected up to the gauges?