SV650.org - SV650 & Gladius 650 Forum



Showing results 1 to 25 of 132
Search took 0.01 seconds.
Search: Posts Made By: andy650
Forum: SV Talk, Tuning & Tweaking 12-06-19, 08:31 PM
Replies: 17
Views: 5,855
Posted By andy650
Re: 2000 Suzuki SV650 (Y) - Speedometer Not Working

the rotor in the wheel is plastic and can easily break the tabs off, which will make the speedo stop reading anything.

was the front tyre changed recently?
Forum: Bikes - Talk & Issues 09-06-19, 07:37 PM
Replies: 19
Views: 2,026
Posted By andy650
Re: How loud is too loud?

What a joke, Heathrow is about to change its flight paths and expose hundreds of thousands of people to far more noise than road vehicles make, all supported by Chris Grayling, at the same time he...
Forum: SV Talk, Tuning & Tweaking 06-06-19, 07:06 PM
Replies: 17
Views: 2,282
Posted By andy650
Re: Anyone tried EBC "V" Semi-Sintered Pads

SBS used to make a low friction version of their pads, specifically for use in the rear, for the reasons stated already. You would never use the low friction version in the front.

The one...
Forum: SV Talk, Tuning & Tweaking 06-06-19, 06:59 PM
Replies: 17
Views: 2,282
Posted By andy650
Re: Anyone tried EBC "V" Semi-Sintered Pads

The front wont be a problem with sintered, it wont make them feel grabby at all. But, the power will be there, without having to heave on the lever, makes for easier riding.

The rear in contrast,...
Forum: SV Talk, Tuning & Tweaking 06-06-19, 04:29 AM
Replies: 17
Views: 2,282
Posted By andy650
Re: Anyone tried EBC "V" Semi-Sintered Pads

I prefer the feel of organic in the rear, less bite and more control. For the front though, fully sintered is much better.

No problems with poor cold weather performance or excessive disk wear,...
Forum: SV Talk, Tuning & Tweaking 28-04-19, 06:09 AM
Replies: 17
Views: 1,994
Posted By andy650
Re: Throttle Body Tuning

If doing a valve clearance check is on your list, you should do that before you do the TB balance.
Forum: SV Talk, Tuning & Tweaking 28-03-19, 09:13 PM
Replies: 15
Views: 1,653
Posted By andy650
Re: Any Experience with Bike-Seal?

Tubeless is easier to change than tubed, a breaker really helps.

Don't bother with the internal tyre sealants, a good old fashioned external plug fitted properly is fine for many miles.

I've...
Forum: SV Talk, Tuning & Tweaking 11-03-19, 07:29 PM
Replies: 27
Views: 2,997
Posted By andy650
Re: Advice on getting my bike going after a long lay off

Decent tools and heat will help split the caliper, but they can be difficult (its probably not been touched in 20 years!)

My SV's fuel light stayed on permanently when the loom rubbed through by...
Forum: SV Talk, Tuning & Tweaking 03-03-19, 08:16 AM
Replies: 27
Views: 2,997
Posted By andy650
Re: Advice on getting my bike going after a long lay off

If the pins are that bad, you will probably find the pistons and seal grooves also need attention, which requires a caliper split.

I would just split the caliper anyway, you may need to cut the...
Forum: SV Talk, Tuning & Tweaking 02-03-19, 06:49 AM
Replies: 10
Views: 1,437
Posted By andy650
Re: Gunk, lube and rust....

1. Toothbrush and WD40
2. No idea
3. Rags and WD40
4. Yes, its that easy. You will need to readjust afterwards as disturbing adj nut.

Dont use petrol, stinky and dangerous.
Forum: SV Talk, Tuning & Tweaking 01-02-19, 05:40 PM
Replies: 36
Views: 9,710
Posted By andy650
Re: sv1000's are now ULEZ exempt

NOX, nor CO2, are the full story. Diesels are terrible on particulates, which will be the next public health scare.

Bikes, in the grand scheme of things, have little impact. Banning the old ones...
Forum: SV Talk, Tuning & Tweaking 16-01-19, 05:29 PM
Replies: 34
Views: 7,310
Posted By andy650
Re: Converting Naked to faired?

I bought a faired for the looks, and when I rode a naked I wish I had bought that instead!

Ended up putting riser bars on my S, and retained the fairing because it was too much hassle to remove...
Forum: SV Talk, Tuning & Tweaking 13-01-19, 07:18 AM
Replies: 34
Views: 7,310
Posted By andy650
Re: Converting Naked to faired?

Welcome BigD, It would be a lot of hassle and cost, not worth it IMHO.

People usually go the other way, the faired ones are pretty common, nakeds not so much.
Forum: SV Talk, Tuning & Tweaking 30-12-18, 08:02 AM
Replies: 4
Views: 943
Posted By andy650
Re: Dash lights on battery dying

Carefully inspect the wiring loom as it passes under the tank hinge.

It is known to wear through to bare wires and short out, giving symptoms you describe.
Forum: Bikes - Talk & Issues 27-12-18, 09:27 PM
Replies: 6
Views: 1,276
Posted By andy650
Re: Stick or twist (repair or get rid)

If you need the money and don't mind doing the work, get a tank and sell it as a runner in the spring. Its not that hard to sort out, and could net you a few hundred for your time.

Otherwise sell...
Forum: SV Talk, Tuning & Tweaking 19-12-18, 09:26 PM
Replies: 8
Views: 1,123
Posted By andy650
Re: Rubber Grommets source?

Cut 1 flange off each of 2 of the 1.6mm ones, and vulcanise them together to make a 3.2mm one?

Repeat 4 times....
Forum: Bikes - Talk & Issues 11-11-18, 07:12 AM
Replies: 9
Views: 1,591
Posted By andy650
Re: Fixing a jacket collar?

I've had success with gluing velcro with copydex glue. Both to its worn out opposite, and to leather.

Apply glue, hold together with a clamp overnight.

Not sure of your exact situation, but...
Forum: SV Talk, Tuning & Tweaking 09-11-18, 07:45 PM
Replies: 21
Views: 3,542
Posted By andy650
Re: SV650sy - the past eight years.

I've owned mine from new, exactly the same as yours in the fab candy blue. 18 years of happy and largely trouble free ownership.

I've done 40k miles on mine, and agree with you about them being...
Forum: SV Talk, Tuning & Tweaking 26-09-18, 04:12 AM
Replies: 21
Views: 5,640
Posted By andy650
Re: Handguards for 2016-

These?

https://www.ebay.co.uk/itm/Motorcycle-LED-Universal-Hand-Guards-Protectors-Aprilia-SHIVER-GT-DORSODURO-1200/291640224830?hash=item43e71cac3e:g:TV8AAOSwxN5WYF5h

I have bigger handguards...
Forum: SV Talk, Tuning & Tweaking 19-09-18, 12:51 PM
Replies: 3
Views: 1,229
Posted By andy650
Re: Rear brake light switch

Take the right hanger off and get to it that way.

It may just need adjusting, or loosening up as they can corrode up.

Cheap enough to replace though.
Forum: SV Talk, Tuning & Tweaking 12-09-18, 04:31 AM
Replies: 17
Views: 3,884
Posted By andy650
Re: ABS Defeat Switch

Nice reasoning OP, I get it.

Had similar problems with a modern GSXS1000 ABS I test rode. Never ridden ABS before so had to test it out, I was surprised how early it cut in, genuinely felt I...
Forum: SV Talk, Tuning & Tweaking 09-09-18, 04:56 AM
Replies: 17
Views: 3,884
Posted By andy650
Re: ABS Defeat Switch

It will affect insurance.

If I was minded to disable ABS, I would probably go for the fuses. Replace them with spade connectors & tails, which go off to your own fuse and switch system.
...
Forum: Bikes - Talk & Issues 07-09-18, 06:44 PM
Replies: 5
Views: 1,152
Posted By andy650
Re: Adaptive bike headlight

That'll be really handy on my roundabout knee down sessions at midnight
Forum: SV Talk, Tuning & Tweaking 06-09-18, 12:29 PM
Replies: 4
Views: 1,852
Posted By andy650
Re: Gearbox F**ked

Dont you just hate that, when both your bikes end up off the road at the same time.

Bad luck, but I tend to agree, another engine or write the poor bike off.
Forum: SV Talk, Tuning & Tweaking 19-07-18, 11:49 AM
Replies: 2
Views: 1,092
Posted By andy650
Re: SV1000 K3 FI light :(

+1 You need dealer mode. Short the 2 pins in the empty white connector under the seat, that will show you the code on the dash. Look it up, and go from there.
Showing results 1 to 25 of 132

 
Forum Jump

All times are GMT. The time now is 11:17 PM.


Powered by vBulletin® - Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.