SV Talk, Tuning & Tweaking Discussion and chat on all topics and technical stuff related to the SV650 and SV1000 Need Help: Try Searching before posting |
![]() |
|
Thread Tools |
![]() |
#1 |
Guest
Posts: n/a
|
![]()
Can you fit a pointy rh engine case and clutch cover on a curvy?
Fed up of the one on my track bike dripping |
![]() |
![]() |
#2 |
Member
Join Date: Mar 2008
Location: Trowbridge, Wiltshire
Posts: 490
|
![]()
I don't know if the designs are the same, but why don't you stick it on a lapping table and give it a good once over? Reassemble with a new gasket and a bit of hylomar, job's a goodun!
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
![]()
Whats a lapping table?
Tried new gasket, tried the best sealent money can buy (well £30 a tube). |
![]() |
![]() |
#4 |
Member
Join Date: Mar 2008
Location: Trowbridge, Wiltshire
Posts: 490
|
![]()
Basically a uniformly flat surface. Get a sheet of very fine sandpaper that's big enough for the whole cover to sit on, stick it on a glass coffee table (cause they're usually nice and flat) and rub the mating surface of the cover over the sandpaper in a figure of 8 motion. If you put some permanent marker on the cover before doing this, you'll see the high-spots where it's not flat, which will probably be where it's leaking.
|
![]() |
![]() |
![]() |
#5 |
Noisy Git
Mega Poster
Join Date: Apr 2007
Location: Halifax/Leeds
Posts: 26,645
|
![]()
Well it will probably be leaking from the low spots... but yeah
__________________
Currently Ex Biker
Now rebuilding a 63' fishing trawler as a dive boat |
![]() |
![]() |
![]() |
#7 |
Guest
Posts: n/a
|
![]()
Got pointy cams to put in it so I'll do it then.
|
![]() |
![]() |
#8 |
Guest
Posts: n/a
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Engine case paint? | beabert | SV Talk, Tuning & Tweaking | 10 | 14-01-10 05:51 PM |
Changing an engine case? | Rich | Bikes - Talk & Issues | 5 | 02-09-09 08:23 PM |
can a pointy engine go in curvy | sottondan | SV Talk, Tuning & Tweaking | 2 | 05-07-08 08:42 AM |
Curvy engine in a pointy | rowdy | SV Talk, Tuning & Tweaking | 3 | 07-06-08 03:59 PM |
snapped engine case bolt | ben650 | SV Talk, Tuning & Tweaking | 15 | 21-11-05 07:59 PM |