Pointy will not run. - SV650.org

11-04-14, 02:50 PM

Hi,
My 2004 SV650 will not run , well it does but only for a few seconds ,then it stops and will re start for a few seconds again .
If I remove the connector from the TPS it will start and "idle" at around 4000 rpm .
Checked all usual stuff , fuel , spark , air etc etc . All there just will not run for more than few seconds .

Really stuck , help .

Thanks ,
Dave . .

Shawthing · 11-04-14, 07:22 PM

Put it in 'Dealer mode' as shown in the TPS thread (just the bit with the wire link in the white connector)
http://forums.sv650.org/showthread.php?t=55459

check for any error codes just after it has failed to run.

COO None No defective part
C12 Crankshaft position sensor (CKPS) Pick-up coil signal, signal generator
C13 Intake air position sensor (ZAPS)
C14 Throttle position sensor (TPS)
C15 Engine coolant temperature sensor (ECTS)
C21 Intake air temperature sensor (IATS)
C23 Tip over sensor (TOS)
C24 Ignition signal #1 (IG coil #1) For #1 cylinder
C25 Ignition signal #2 (IG coil #2) For #2 cylinder
C28 Secondary throttle valve actuator (STVA)
C29 Secondary throttle position sensor (STPS)
C31 Gear position signal (GP switch)
C32 Fuel injector signal #1 For #1 cylinder
C33 Fuel injector signal #2 For #2 cylinder
C41 Fuel pump control system (FP control system) Fuel pump relay
C42 Ignition switch signal (IG switch signal) Anti-theft
C49 PAIR control solenoid valve

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ideas please	busasean	Idle Banter	6	29-02-08 05:41 PM
Any Ideas?	melody	2007 Annual Rideout	22	17-06-07 12:55 PM
Out of ideas on this......help please.	POGS69	SV Talk, Tuning & Tweaking	29	24-05-07 07:51 AM
Oil.. Any ideas?????	k3lls	SV Talk, Tuning & Tweaking	11	04-05-06 01:08 PM

11-04-14, 02:50 PM	#1
DNA Guest Posts: n/a	Pointy will not run. Hi, My 2004 SV650 will not run , well it does but only for a few seconds ,then it stops and will re start for a few seconds again . If I remove the connector from the TPS it will start and "idle" at around 4000 rpm . Checked all usual stuff , fuel , spark , air etc etc . All there just will not run for more than few seconds . Really stuck , help . Thanks , Dave . .

11-04-14, 07:22 PM	#2
Shawthing Member Join Date: May 2011 Location: Manchester Posts: 396	Re: Pointy will not run. Put it in 'Dealer mode' as shown in the TPS thread (just the bit with the wire link in the white connector) http://forums.sv650.org/showthread.php?t=55459 check for any error codes just after it has failed to run. COO None No defective part C12 Crankshaft position sensor (CKPS) Pick-up coil signal, signal generator C13 Intake air position sensor (ZAPS) C14 Throttle position sensor (TPS) C15 Engine coolant temperature sensor (ECTS) C21 Intake air temperature sensor (IATS) C23 Tip over sensor (TOS) C24 Ignition signal #1 (IG coil #1) For #1 cylinder C25 Ignition signal #2 (IG coil #2) For #2 cylinder C28 Secondary throttle valve actuator (STVA) C29 Secondary throttle position sensor (STPS) C31 Gear position signal (GP switch) C32 Fuel injector signal #1 For #1 cylinder C33 Fuel injector signal #2 For #2 cylinder C41 Fuel pump control system (FP control system) Fuel pump relay C42 Ignition switch signal (IG switch signal) Anti-theft C49 PAIR control solenoid valve __________________ SK9 Sport Black Delkevic can. Non arbores caesa suum mittere nuntius, sed magnum numerum electrons uehementissime incommo. Last edited by Shawthing; 11-04-14 at 07:34 PM.