My **** - tail tidy

[Wideboy]

also its probably better to make it out of 1.5 - 2mm, i used 3 mm and it was a pain in the ar5e to do the little bend in it

i clammed it to the bench and put all my weight on it and it barely moved, i resorted to sitting on it and jumping up and down

[yorkie_chris]

You have never seen the YC school of fabrication.

Bench vice, big hammer, gas torch.

[Wideboy]

Originally Posted by yorkie_chris

You have never seen the YC school of fabrication.

Bench vice, big hammer, gas torch.

oow oww and another thing, on the bit i circled in the pic, you want to bend a slight upwards curve in them so it all sits flush when held up fairing



thats all your getting, i dont want to be rendered completely useless

hey gave, can you dad make me a plate as i wana make a tail tidy on the cheep and think that with the l-plate on aswell it reli does need a lil plate, do you recon pc plob will agree?

[Wideboy]

Originally Posted by Spike1105

hey gave, can you dad make me a plate as i wana make a tail tidy on the cheep and think that with the l-plate on aswell it reli does need a lil plate, do you recon pc plob will agree?

i asked him to make me one but he said bye the time he's bought the materials it would be cheaper to go and get it done somewhere else, can only bye a minimum of 5M of the stuff you see so unless he makes loads its not worth it

u can get the on ebay for ?5, ?7 including postage

[Wideboy]

Originally Posted by Spike1105

u can get the on ebay for ?5, ?7 including postage

but im getting one done for free because im in the know

but you just said its not worth it, unless u get a bulk order,

[Wideboy]

Originally Posted by Spike1105

but you just said its not worth it, unless u get a bulk order,

not through my dad

ah, hook a brother up!