Slow Rev Limiter Bounce on K6

[Red ones]

From SVRider:
C42 is ignition input to ecu not present. Check the 4 pin green connector below tank open and spray in contact cleane then remake. If you have a volt meter you should have around 6vdc from the orange/ red wire to ground when the ignition is on. If not likely the ignition switch at fault.

[auronini]

Cheers i'll have a look at that, got exams in a couple weeks now so i'll have a look when they're done and see if it fixes anything

Originally Posted by Craig380

The other point is that the SV revcounter is optimistic - over-reading by over 10% at higher rpm, so that when the needle is showing 11,000, actual RPM is under 10,000. See this thread from SVRider: http://www.svrider.com/forum/showthread.php?t=138676

Mine seems to hit 11900rpm on the 2 or 3 times I've hit the limiter, then bounce between that and about 11500rpm.

Botched changes and me not changing up when having a blast are to blame !!