SV650.org - SV650 & Gladius 650 Forum

SV650.org - SV650 & Gladius 650 Forum (http://forums.sv650.org/index.php)
-   SV Talk, Tuning & Tweaking (http://forums.sv650.org/forumdisplay.php?f=111)
-   -   Possible developing oil leak? (http://forums.sv650.org/showthread.php?t=145475)

Taipan 21-01-10 02:27 PM

Possible developing oil leak?
 
I think I may have an oil leak from around the gearbox sprocket or gear change shaft, certainly on that side in that sort of area anyway. Are the Curvys known for any particular oil seal fails around there? Assuming it is one of them how bad a job is replacement?
Many thanks.

Dave20046 21-01-10 02:29 PM

Re: Possible developing oil leak?
 
I've read somewhere about it running from one of the shafts or possibly clutch pushrod out of the engine (read it on here I think). Might be worth taking the sprock cover off to have a gander.

dizzyblonde 21-01-10 03:50 PM

Re: Possible developing oil leak?
 
It could be worth checking that you haven't adjusted your chain too tightly, or at least one part is less stretched than the rest.
Reason I say is because I developed an oil leak from the sprocket area and it was the rubber sprocket seal that had moved enough to let oil out, after the chain had been adjusted. Brand new chain but half of it decided not to wear at the same rate as the other.

Was a head scratcher at the GM last year. Sat on the bike and the chain went so tight there was no movement. Backed it off and it has been fine since, as the sprocket seal re-seated itself.

Dave20046 21-01-10 05:07 PM

Re: Possible developing oil leak?
 
Quote:

Originally Posted by dizzyblonde (Post 2156790)
Was a head scratcher at the GM last year. Sat on the bike and the chain went so tight there was no movement. Backed it off and it has been fine since, as the sprocket seal re-seated itself.

Had you been training for the bobsled team? :razz:

dizzyblonde 21-01-10 05:53 PM

Re: Possible developing oil leak?
 
phnar!
NO cheeky git!.
It was just the way the chain had worn in. Badly adjusted in the way it had only been looked at on one half, and we thought it needed it. The other half was too tight....suprised it didn;t do a Gr33k and snap on the motorway!

Dave20046 21-01-10 06:11 PM

Re: Possible developing oil leak?
 
Quote:

Originally Posted by dizzyblonde (Post 2156900)
phnar!
NO cheeky git!.
It was just the way the chain had worn in. Badly adjusted in the way it had only been looked at on one half, and we thought it needed it. The other half was too tight....suprised it didn;t do a Gr33k and snap on the motorway!

hehe, was only jokin that's why I wheel the bike til the tightest bit of the chain is under the swing arm then sit on it lean back and feel the slack.

dizzyblonde 21-01-10 06:16 PM

Re: Possible developing oil leak?
 
Its ok for you, you have arms like apehangers..long!!

I knows you're kidding. But it wasn't me that adjusted it. It was Carnivore. Mind you it was him that told me what it was straight away, as soon as he saw the leak, without even looking at the chain. The evidence only backed up his first guess..jammy git!

vardypeeps 22-01-10 01:03 PM

Re: Possible developing oil leak?
 
Scottoiler turned up too high?
I;ve had this before where it's collected behind the front sprocket cover (still wet) and then dripped down looking like an oil leak.

Don't start you engine with the clutch push rod removed as it squirts out everywhere (D'oh)

Taipan 28-01-10 03:49 PM

Re: Possible developing oil leak?
 
Its definitely engine oil thats coming out. I cant work out if its the gearbox seal or the clutch pushrod one? I'll clean it up at the weekend and see which one it is. What sort of job is replacing these?

fastdruid 28-01-10 04:32 PM

Re: Possible developing oil leak?
 
Quote:

Originally Posted by vardypeeps (Post 2157653)
Don't start you engine with the clutch push rod removed as it squirts out everywhere (D'oh)

Oh yes it does, and boy does it go a *long* way!

Druid

yorkie_chris 29-01-10 01:46 PM

Re: Possible developing oil leak?
 
Also loose front sprocket nut can let oil out, but then it tends to come out rather quickly!

Grinch 29-01-10 01:54 PM

Re: Possible developing oil leak?
 
Quote:

Originally Posted by yorkie_chris (Post 2164657)
Also loose front sprocket nut can let oil out, but then it tends to come out rather quickly!

As Yorkie says the seal for the front sprocket can leak if the sprocket is loose. Though I find it only a issue when your running the bike hard, say above 6k, as I've managed to leak on the motorway journey to work and then wonder why it stopped when I was bimbling round town.

fastdruid 29-01-10 01:58 PM

Re: Possible developing oil leak?
 
Quote:

Originally Posted by yorkie_chris (Post 2164657)
Also loose front sprocket nut can let oil out, but then it tends to come out rather quickly!

Its worth noting again here that sprocket nuts do loosen over time, even when torqued up, locktited and properly lock washered!

(I think its actually wear rather than the nut loosens but the effect is the same).

Check your nuts every service!

Druid

Grinch 29-01-10 02:03 PM

Re: Possible developing oil leak?
 
This is the one you need to check -

http://farm4.static.flickr.com/3512/...62ef2720_m.jpg

Taipan 29-01-10 02:10 PM

Re: Possible developing oil leak?
 
Interesting. What with this, iffy brakes, new fork springs/oil, it looks like a busy weekend!

Thanks everyone.

Taipan 01-02-10 12:57 PM

Re: Possible developing oil leak?
 
Quote:

Originally Posted by yorkie_chris (Post 2164657)
Also loose front sprocket nut can let oil out, but then it tends to come out rather quickly!

Its iis loose and only held tightish by the washer thing. Anyone know the torque setting for this?

punyXpress 01-02-10 01:00 PM

Re: Possible developing oil leak?
 
145 Nm per Haynes

Taipan 01-02-10 01:02 PM

Re: Possible developing oil leak?
 
Quote:

Originally Posted by punyXpress (Post 2167391)
145 Nm per Haynes

Top man. Thank you. :)

yorkie_chris 01-02-10 01:41 PM

Re: Possible developing oil leak?
 
Otherwise known as FT

fastdruid 01-02-10 02:29 PM

Re: Possible developing oil leak?
 
Quote:

Originally Posted by Taipan (Post 2167385)
It is loose and only held tightish by the washer thing.

See, told you it works its way loose!

Druid

Spanner Man 02-02-10 08:33 AM

Re: Possible developing oil leak?
 
Good morning all.


The lock washer should be changed every time a chain & sprocket is relplaced, & it's not a bad idea to replace the nut also, when changing a chain & sprockets. As, the factory loctite that comes applied to a new nut seems to do the job.
If re-using the old nut, one must remove all traces of the old Loctite from the nut & the threads on the shaft, & use a decent industrial Loctite.


Cheers.

yorkie_chris 02-02-10 10:51 AM

Re: Possible developing oil leak?
 
I dunno about every time, I just bend each one up on opposite sides. 6 flats on the nut = new washer every 3 sprockets.

Grinch 02-02-10 10:56 AM

Re: Possible developing oil leak?
 
Replace? Replace? Nah.

Note this is my view, I can't be held responsible if your front sprocket falls off.

Spanner Man 02-02-10 05:20 PM

Re: Possible developing oil leak?
 
Quote:

Originally Posted by yorkie_chris (Post 2168426)
I dunno about every time, I just bend each one up on opposite sides. 6 flats on the nut = new washer every 3 sprockets.

Bodger!!!!!:D

Spanner Man 02-02-10 05:21 PM

Re: Possible developing oil leak?
 
Quote:

Originally Posted by Grinch (Post 2168436)
Replace? Replace? Nah.

Note this is my view, I can't be held responsible if your front sprocket falls off.


Another Bodger!!!!:D:D

Alpinestarhero 02-02-10 06:28 PM

Re: Possible developing oil leak?
 
Quote:

Originally Posted by Spanner Man (Post 2168904)
Another Bodger!!!!:D:D

http://memories-tv.com/bodger.jpg

:cheers:

beabert 02-02-10 11:52 PM

Re: Possible developing oil leak?
 
lol bodger and badger

Spanner Man 03-02-10 08:15 AM

Re: Possible developing oil leak?
 
Quote:

Originally Posted by beabert (Post 2169527)
lol bodger and badger


That's the trouble with these university types like Alpinestarhero, THEY CAN'T SPELL!!!:D

Taipan 21-04-10 01:04 PM

Re: Possible developing oil leak?
 
Quote:

Originally Posted by fastdruid (Post 2167514)
See, told you it works its way loose!

Druid

You certainly weren't wrong as it did it again! Bent both sides of the washer over properly this time though. Still didn't replace it mind!:rolleyes:


All times are GMT. The time now is 01:58 PM.

Powered by vBulletin® - Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.