Arrrrgggh. Bar End Screw Not Budging
 

Anyone got a clever way of getting these off.
Mine is not moving. Tried normal screwdriver. Rachet with Screwdiver bit (broke the screwdriver head). Tried heating it up with a heat shrink gun for a few mins to see if the glue (if theres is some) would melt and loosen. All with no luck.
Can anyone help me?

Re: Arrrrgggh. Bar End Screw Not Budging
 

Have you got an impact driver?
If you're not worried about the bar ends, you could use mole grips I guess, to see if that'd budge it.

Re: Arrrrgggh. Bar End Screw Not Budging
 

Just soak it in WD40 as good as you can, then screw back in then screw loose.

Re: Arrrrgggh. Bar End Screw Not Budging
 

Or try penetrating oil.

Re: Arrrrgggh. Bar End Screw Not Budging
 

Have done the WD40 thing too. :(
Plowsie I can't get the damn thing to move at all let alone be able to screw it in first :)
You know how usually you can turn the bar end round whilst still on the bar well this is solid.

Re: Arrrrgggh. Bar End Screw Not Budging
 

they are only rubber bungs that the screw go into - just try pulling it out ?
or try and squirt some WD down inside - worth a try

Spokey ( formerly Nana )

Re: Arrrrgggh. Bar End Screw Not Budging
 

Right Chris, where are ya? Home or work?

Re: Arrrrgggh. Bar End Screw Not Budging
 

:confused:

My curvy clip ons were solid with a threaded hole through them, no rubber I don't think?

Re: Arrrrgggh. Bar End Screw Not Budging
 

Plowsie im at work. Lots of tools. Fancy a go? :)

Re: Arrrrgggh. Bar End Screw Not Budging
 

No rubber through mine. The other came off easy peasy and its threaded into the metal.