Hole in intake rubber?
 

Cleaned up my secondhand engine and put it on the bench ready for the rebuild and i noticed a hole in the rear rubber tube the carbs go onto. Does a vacuum hose go into it or has it been bored for a scotoiler vacumm hose feed. thanks Cammy:(

Re: Rubber boots
 

What engine?

http://forums.sv650.org/showthread.php?t=71305

Re: Hole in intake rubber?
 

Sorry sv650 1999

Re: Hole in intake rubber?
 

Vacuum hose, should have a brass spigot on it.

Re: Hole in intake rubber?
 

There is no carbs mounted on the engine yet still to get them just the rubber mounts on engine if this helps

Re: Hole in intake rubber?
 

Vacuum for the fuel tap comes from the rear carb. Vacuum for the fuel pump comes from the hole ... it should be on the right hand side of the rear rubber IIRC.

A tube pushes onto a brass spigot. If it's just a hole then they've probbly yanked the hose and spigot out. as one bit.

Re: Hole in intake rubber?
 

And its on the rear boot none on front the boot

Re: Hole in intake rubber?
 

Thanks spot on looked on parts drawings but did not see anything so thats why i asked thanks again hope u can buy one :D

Re: Hole in intake rubber?
 

Just take the intake boot off tother motor when you swap it...

Re: Hole in intake rubber?
 

Dont have another engine building from scratch i have got a real challenge the site will be fed up with my questions ;)