Handlebar mounts
 

Having no luck in sourcing second hand mounts/clamps for a 2000 reg naked yoke and handlebars.
A local engineering shop said they could make up clamps for around £60.
Bit worried they will be strong enough, didnt ask exactly what they would be made from!
Anyone else went down this route?
£60 an ok price?

Re: Handlebar mounts
 

which bits are you wanting exactly? The risers which bolt to the yoke and hold the handlebars in place?

If so I've bought them secondhand for £30 ish. Bandit ones are about the same, in fact nearly any naked bike.

Re: Handlebar mounts
 

Thats what Im needing chris, cant get second hand ones anywhere.
Priced new ones from Suzuki, nearly fainted at the price!
Does any bandit ones fit?

Re: Handlebar mounts
 

I bought Renthal ones new off ebay for ~£25 or so. There were lots on there, but I expect you'd have to be careful-ish as the bolt sizes seem to vary.

Re: Handlebar mounts
 

IIRC (will check in a minute) stock SV650 bolt to hold the riser to the yoke is an M10 and the bolts to clamp the risers together are M6.

There is LOADS of meat in the top yoke if you had to drill it out to M12 or something though.

Re: Handlebar mounts
 

Have seen a few renthal ones on ebay for 22mm bars, but dont mention the fixing bolt size or have double bolts to fit to the yoke.
And are they called clamps, mounts or risers?
The parts link at the top of the page calls them HOLDER HANDLE LOWER and HOLDER HANDLE UPPER!

Re: Handlebar mounts
 

Risers, usually.

These look close and I think that's the kinda price to pay too.

Re: Handlebar mounts
 

Standard bars are 22mm or 7/8".

Those on the eBay link are REALLY high, stock is only like 20mm of rise and even then you benefit from lower bars.

Re: Handlebar mounts
 

They look ok, but is 90mm not too high, or am I reading that wrong.

Re: Handlebar mounts
 

Or these

they say they're lower than the others, but no mention of the mount to the yoke, my risers are angled back and it helps with screen clearance.