![]() |
Balancing wheels on the bike
Is it possible? ie: with the bike lifted off the ground and the wheels fitted to the bike (chain removed from the sprocket at the rear) will the wheels turn freely enough on the wheel bearings for gravity to expose a heavy spot in a tyre?
I know it would depend on how heavy the heavy spot is, but lets say 10 grams or more, significant enough to cause a vibration. Assume free running and properly greased wheel bearings. I'll try it at the weekend by sticking a 10 gram weight on a balanced wheel and see if it turns, until then, any thoughts? Thanks |
Re: Balancing wheels on the bike
I couldn't, was ages ago, so cant remember which bike i tried it on. If you have success, ill be trying again.
|
Re: Balancing wheels on the bike
No its not.
|
Re: Balancing wheels on the bike
No, too much drag from dust seals and stuff.
|
Re: Balancing wheels on the bike
With completely worn out seals, very loose bearings, pads levered away from the discs and the chain removed etc. it might sort of work on the rear. On the front you have the additional drag of the speedo sensor.
|
Re: Balancing wheels on the bike
id be interested if someone can come up with a diy version of a wheel balancer. has anyone got a bought balancer that can give us insight into how it does the job? could we use the wheel axle rod as part of a diy version?
|
Re: Balancing wheels on the bike
ABBA do one, but you'd need to be doing a lot to justify the cost.
However it doesn't look too difficult to make something similar http://www.abbastands.co.uk/product_details.asp?id=14 |
Re: Balancing wheels on the bike
wheel balancer is basically 2 cones a rod and some tiny low friction bearings. i have one and don't use it as i have found something else which works.
|
Re: Balancing wheels on the bike
Set of axle stands and a socket extension through the bearings, works fine.
|
Re: Balancing wheels on the bike
Quote:
|
All times are GMT. The time now is 04:19 PM. |
Powered by vBulletin® - Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.