OEM Bar Ends - where from?
 

Afternoon all,

I seem to have lost the bar end on right grip. I'm told this could be a common issue with the SV as it vibrates so much, has this happened to anyone else?

If so, where did you source an OEM replacement from - I don't want to spend a fortune on them if it's going to keep happening.

Thanks
Dan

Re: OEM Bar Ends
 

Its usually the opposite, most bar ends are permanently attached as the screw gets rusted in place

There's quite a few pattern or similar ones made by Oberon on Ebay at next to nothing

http://www.ebay.co.uk/sch/i.html?_tr...at=0&_from=R40

Don't but the ones with the expander bolt unless your bars aren't standard or have a rubber grommet with a nut inside it, sometimes these fall apart and the nut isn't held in place by the grommet any longer.

SV's don't vibrate that much

Re: OEM Bar Ends
 

OEM on EBAY

http://www.ebay.co.uk/sch/i.html?_sa...temCondition=4

Re: OEM Bar Ends - where from?
 

Thanks guys - I've only had her 8 weeks so no chance of them being rusted in. Also, when I bought it - the shop fitted Daytona heated grips for me so I can only assume it wasn't done back up tight enough. Just checked the left and that was fairly loose too - so will look at the ones on eBay ending tonight. Quite like the purple ones too - they look sweet!

Re: OEM Bar Ends - where from?
 

NOOOOOOOOOOOOOOOOO don't get the purple ones :D

Re: OEM Bar Ends - where from?
 

Nooooooooooooooooooooooooooooo, don't listen to Maviczap, purple is an awesome colour! :smt005

Re: OEM Bar Ends - where from?
 

So are these aluminium or stainless steel? Read the whole listing carefully!

Re: OEM Bar Ends
 

Agree, no bar ends fitted at all here

Re: OEM Bar Ends - where from?
 

Sweet, won the auction for the adonised ones! Now, i'll make sure they're tight this time! They're alloy ones..